Bicast Cleaner 1.5

Bicast Cleaner 1.5 by Leather Doctor is a pH 1.5 balanced leather cleaner to removes body oil grease sweat and harmful cleaners prevent it from becoming sticky.

Bicast Cleaner 1.5 is formulated to work with Leather Degreaser 2.2, Leather Acidifier 2.0, and Leather Protector B in a holistic system to solve and control leather sticky problems. A more permanent solution is to repair or rejuvenate the leather finishing with a fresh coating of Bicast Gloss Top Coat 76G with Leather Crosslinker 25.

How to Use Bicast Cleaner 1.5 to Control Mild Leather Stickiness?

Concentrates in the bottle have to be mixed with distilled water before use.

1* Apply Bicast Cleaner 1.5 and brush with Leather Brush 1 to remove surface soiling and towel extract until towel shows clean.

2* Spray Acidifier 2.0 and brush with Leather Brush 1 let dwell a few minutes to pH balance potential stickiness and towel extract until the towel shows clean.

3* Let dry, and inspect with hand to check for stickiness, if stickiness has improved and a temporary solution suffices, Protector B may end the temporary problem.

People Also Ask:

1* What is the Cause of Sticky Bicast Leather?

2* How to Rectify Sticky Bicast Leather?

3* What is the Working System of Bicast Cleaner 1.5?

4* How to Restore the Sticky Finishes?

1* What is the Cause of Sticky Bicast Leather?

Sticky Bicast leather is mainly the result of accumulated body oil, grease, and sweat; long storage; exposure to inert gases; and further alkaline cleaners, incompatible oils, and conditioners often compound it.

2* How to Rectify Sticky Bicast Leather?

Sticky Bicast leather is rectified with Bicast Cleaner 1.5 with its low pH value of 1.5 to tighten up the swelling of the urethane finishes at the molecular level thus reducing the stickiness.

3* What is the Working System of Bicast Cleaner 1.5?

Bicast Cleaner 1.5 works in conjunction with Degreaser 2.2 to remove the stuck fabric and complimentary Acidifier 2.0 as a rinse to further reinforce the working effect.

4* How to Restore the Sticky Finishes?

The surface is inspected and tested for satisfaction. Protector B a non-stick protector ends the temporary sticky rectification process.

In extreme cases where stickiness persists, refinishing the urethane topcoat with Bicast Gloss Topcoat 76G and Leather Crosslinker 25 as a hardener is highly recommended to end the sticky problem. Protector B imparts a non-stick surface to help reduce potential stickiness.