Product Overview
Leather Doctor® Kit-N5.hs, nubuck leather tarnish stain removal kit is designed to remove practically most stains that derive from metal including the rusty stain after the protein component of the blood is removed. d’Tarnish-1.3 works by chemical reaction dwelling until it is naturally dry for the product to take effect. Basifier-8.8 neutralizes the low pH with the same dwelling and let dry naturally as well. Hydrator-3.3 relaxes stiff leather and reduces surface tension for an even appearance prior to fat and oil replenishing. Fatliquor-5.0 replenishing rejuvenates the leather structure for softness and strength when dry. The surface wear of the leather is greatly reduced with a rub-resistant Protector-S+ that enhances a non-stick silky-feel to shield against sticky soiling. Note that the mentioned products suffix numbers denotes its pH value in this holistic approach to removing metal derived from nubuck leathers.
Instruction
Stain Removal
1. Apply d’Tanish-1.3 onto the stain, agitate with nubuck Brush-2 / Eraser-4 and towel extract until it shows clean.
2. Saturate the remaining stain until natural dry to allow product continuous reaction.
3. When stain vanished, neutralize with Basifier-8.8 by applying and letting it dwell until natural dry.
4. Erase wick-up residue with Eraser-4 prior to hydrating.
Hydrating
1. Hydrator-3.3 is applied to plumps the leather and prepares the surface for an even appearance prior to fat and oil replenishing.
Fat and Oil Replenishing
1. Spray Fatliquor-5.0 and redistribute evenly with foam brush until fully saturated.
2. Repeat reapplication when water content evaporates until fully saturated.
3. Let natural dry for extra softness and wick up soiling particulates is erased when crispy dry.
Non-stick, Rub-Resistant Protection
1. Shake well, mist spray Protector-S+ evenly and brush-in with nubuck Brush-2,
2. When dry thereafter groom with nubuck Brush-2 again for a silky finger writing effect and it is ready for use.